R211x-HP Flexfabric 11900 IP Multicast Configuration Guide

179
Uptime: 00:05:26
Candidate BSR address: 4002::1
Priority: 10
Hash mask length: 128
# Display BSR information on Switch E.
[SwitchE] display ipv6 pim bsr-info
Scope: non-scoped
State: Elected
Bootstrap timer: 00:01:48
Elected BSR address: 1003::2
Priority: 20
Hash mask length: 128
Uptime: 00:01:10
Candidate BSR address: 1003::2
Priority: 20
Hash mask length: 128
# Display RP information on Switch A.
[SwitchA] display ipv6 pim rp-info
BSR RP information:
Scope: non-scoped
Group/MaskLen: FF0E::101/64
RP address Priority HoldTime Uptime Expires
1003::2 192 180 00:05:19 00:02:11
4002::1 192 180 00:05:19 00:02:11
IPv6 PIM-SM admin-scoped zone configuration example
Network requirements
As shown in Figure 55:
• VOD streams are sent to receiver hosts in multicast. The entire IPv6 PIM-SM domain is divided into
IPv6 admin-scoped zone 1, IPv6 admin-scoped zone 2, and the IPv6 global-scoped zone. Switch B,
Switch C, and Switch D are ZBRs of the three zones, respectively.
• Source 1 and Source 2 send different IPv6 multicast data to the IPv6 multicast group FF14::101. Host
A receives the IPv6 multicast data only from Source 1, and Host B receives the IPv6 multicast data
only from Source 2. Source 3 sends IPv6 multicast data to the IPv6 multicast group FF1E::202. Host
C is an IPv6 multicast receiver for the IPv6 multicast group FF1E::202.
• VLAN-interface 101 of Switch B acts as a C-BSR and a C-RP for IPv6 admin-scoped zone 1.
VLAN-interface 105 of Switch D acts as a C-BSR and a C-RP for IPv6 admin-scoped zone 2. Both of
the two interfaces are designated to the IPv6 multicast groups with the scope field value of 4.
VLAN-interface 109 of Switch F acts as a C-BSR and a C-RP for the IPv6 global-scoped zone, and
it is designated to the IPv6 multicast groups with the scope field value of 14.
• MLDv1 runs between Switch A, Switch E, Switch I, and the receivers that directly connect to them,
respectively.