R211x-HP Flexfabric 11900 IRF Command Reference

15
• TRILL is configured. Retain the IRF bridge MAC address for TRILL to maintain a correct network
topology.
• VRRP load balancing is used. For more information about VRRP, see High Availability Configuration
Guide.
If two IRF fabrics have the same bridge MAC address, they cannot merge.
Examples
# Enable the IRF bridge MAC address to be permanent.
<Sysname> system-view
[Sysname] irf mac-address persistent always
irf member
Use irf member to assign a member ID to the device in standalone mode.
Use undo irf member to restore the default.
Syntax
irf member member-id
undo irf member
Default
The device operates in standalone mode and has no member ID.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
member-id: Assigns an IRF member ID to the device. The value range for the member ID is 1 to 4. For a
successful two-chassis IRF setup, you must assign member ID 1 or 2 to the member device that has OAA
cards.
Usage guidelines
You must assign an IRF member ID to a device before enabling its IRF mode. The member ID takes effect
after the IRF mode is enabled. This member ID must be unique among all IRF member devices.
To change the member ID of a device in IRF mode, use the irf member member-id renumber
new-member-id command. The new member ID takes effect at reboot.
Examples
# Assign member ID 2 to the device in standalone mode.
<Sysname> system-view
[sysname] irf member 2
Info: Member ID change will take effect after the member reboots and operates in IRF mode.
Related commands
irf member renumber