R211x-HP Flexfabric 11900 IRF Command Reference

The system activates the IRF port settings automatically in the following situations:

• The configuration file that the device starts with contains IRF port bindings.

• You are binding physical ports to an IRF port in up state.

Examples

To configure and activate IRF port 1/2:

# Bind Ten-GigabitEthernet 1/1/0/27 to it.

<Sysname> system-view

[Sysname] interface ten-gigabitEthernet 1/1/0/27

[Sysname-Ten-GigabitEthernet1/1/0/27] shutdown

[Sysname-Ten-GigabitEthernet1/1/0/27] quit

[Sysname] irf-port 1/2

[Sysname-irf-port1/2] port group interface ten-gigabitethernet 1/1/0/27

Info : You are recommended to save the configuration now; otherwise, it will be lost after

system reboot.

[Sysname-irf-port1/2] quit

[Sysname] interface ten-gigabitethernet 1/1/0/27

[Sysname-Ten-GigabitEthernet1/1/0/27] undo shutdown

[Sysname-Ten-GigabitEthernet1/1/0/27] quit

# Save the configuration so the IRF port settings can take effect after the device reboots.

[Sysname] save

The current configuration will be written to the device. Are you sure? [Y/N]:y

Please input the file name(*.cfg)[flash:/startup.cfg]

(To leave the existing filename unchanged, press the enter key):

flash:/startup.cfg exists, overwrite? [Y/N]:y

Validating file. Please wait............................

Saved the current configuration to mainboard device successfully.

Chassis 1 Slot 1:

Save next configuration file successfully.

Configuration is saved to device successfully.

# Activate the IRF port settings.

[Sysname] irf-port-configuration active

mad bfd enable

Use mad bfd enable to enable BFD MAD.

Use undo mad bfd enable to disable BFD MAD.

Syntax

mad bfd enable

undo mad bfd enable

Default

BFD MAD is disabled.

Views

VLAN interface view