R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Command Reference

101
Do not enable both spanning tree and link-aggregation traffic redirection at the same time, because light
packet loss might occur when a card or the device reboots.
Examples
# Enable link-aggregation traffic redirection.
<Sysname> system-view
[Sysname] link-aggregation lacp traffic-redirect-notification enable
link-aggregation load-sharing mode
Use link-aggregation load-sharing mode to configure the link-aggregation load sharing criteria.
Use undo link-aggregation load-sharing mode to restore the default setting.
Syntax
link-aggregation load-sharing mode { { destination-ip | destination-mac | mpls-label1 | mpls-label2 |
source-ip | source-mac } * | flexible }
undo link-aggregation load-sharing mode
Default
The load sharing criteria are the same as the global load sharing criteria.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
destination-ip: Performs load sharing in link aggregation groups based on destination IP address.
destination-mac: Performs load sharing in link aggregation groups based on destination MAC address.
mpls-label1: Performs load sharing for MPLS traffic based on Layer 1 label.
mpls-label2: Performs load sharing for MPLS traffic based on Layer 2 label.
source-ip: Performs load sharing in link aggregation groups based on source IP address.
source-mac: Performs load sharing in link aggregation groups based on source MAC address.
flexible: Performs load sharing in link aggregation groups flexibly based on packet types (Layer 2, IPv4,
IPv6, or MPLS for example).
Usage guidelines
The load sharing criteria that you configure overwrites the previous criteria.
If unsupported load sharing criteria are configured, an error prompt appears.
In Layer 2 aggregate interface view, the switch supports the following load sharing criteria and
combinations:
• Source IP address
• Destination IP address
• Source MAC address