R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Command Reference
104
Examples
# Set the port priority of Layer 2 Ethernet interface Ten-GigabitEthernet 1/0/1 to 64.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] link-aggregation port-priority 64
Related commands
lacp system-priority
link-aggregation selected-port maximum
Use link-aggregation selected-port maximum to configure the maximum number of Selected ports
allowed in an aggregation group.
Use undo link-aggregation selected-port maximum to restore the default setting.
Syntax
link-aggregation selected-port maximum number
undo link-aggregation selected-port maximum
Default
For an SF card, the maximum number of Selected ports allowed in an aggregation group is 32.
For a non-SF card, the maximum number of Selected ports allowed in an aggregation group is 8.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
number: Specifies the maximum number of Selected ports allowed in an aggregation group. The value
range is 1 to 32. The maximum number of effective Selected ports in an aggregation group depends on
the card model.
• For an SF card, the maximum number of Selected ports allowed in an aggregation group is 32.
• For a non-SF card, the maximum number of Selected ports allowed in an aggregation group is 8.
Usage guidelines
Executing this command might cause some of the Selected ports in an aggregation group to become
Unselected.
The maximum numbers of Selected ports allowed in the aggregation groups of the local and peer ends
must be consistent.
The maximum number of Selected ports allowed in an aggregation group is limited by either the
configured maximum number or hardware capability, whichever value is smaller.
You can configure backup between two ports by assigning two ports to an aggregation group and
configuring the maximum number of Selected ports allowed in the aggregation group as 1. In this way,
only one Selected port is allowed in the aggregation group at any point in time, while the Unselected
port serves as a backup port.