R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Command Reference

143
Default
No Agreement Check is disabled.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
This command takes effect only after you enable it on the root port.
When the setting is configured in Layer 2 Ethernet interface view, it takes effect on only that interface.
When the setting is configured in Layer 2 aggregate interface view, it takes effect on only the aggregate
interface.
When the setting is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
Examples
# Enable No Agreement Check on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] stp no-agreement-check
stp pathcost-standard
Use stp pathcost-standard to specify a standard for the device to use when calculating the default path
costs for ports.
Use undo stp pathcost-standard to restore the default.
Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
Default
The devices uses the legacy standard to calculate the default path costs for ports.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
dot1d-1998: Configures the device to calculate the default path cost for ports based on IEEE
802.1d-1998.
dot1t: Configures the device to calculate the default path cost for ports based on IEEE 802.1t.