R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Command Reference

161
loopback-detection enable
Use loopback-detection enable to enable loop detection on a port.
Use undo loopback-detection enable to disable loop detection on a port.
Syntax
loopback-detection enable vlan { vlan-list | all }
undo loopback-detection enable vlan { vlan-list | all }
Default
The loop detection function is disabled on ports.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
vlan-list: Specifies a VLAN list, in the format of { vlan-id [ to vlan-id ] }&<1-10>, where vlan-id represents
the VLAN ID in the range of 1 to 4094, and &<1-10> indicates that you can specify up to 10 vlan-id [ to
vlan-id ] parameters.
all: Specifies all existing VLANs.
Usage guidelines
Use this command to enable loop detection on specific ports. The port-specific loop detection
configuration takes effect only after you enable loop detection globally. To enable loop detection
globally, use the loopback-detection global enable command.
The global configuration applies to all ports in the specified VLAN. The per-port configuration applies to
the individual port only when the port belongs to the specified VLAN. The per-port configuration takes
precedence over the global configuration.
Example
# Enable loop detection on port Ten-GigabitEthernet 1/0/1 for VLAN 10 through VLAN 20.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[System-Ten-GigabitEthernet1/0/1] loopback-detection enable vlan 10 to 20
Related commands
• display loopback-detection
• loopback-detection global enable
loopback-detection global action
Use loopback-detection global action to configure the global loop protection action.
Use undo loopback-detection global action to restore the default.