R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Command Reference

11
Field Description
Bandwidth Expected bandwidth of the interface.
Internet protocol processing: disabled Indicates that the interface cannot process IP packets.
Last clearing of counters
Time when the reset counters interface command was last used to
clear the interface statistics. Never indicates the reset counters
interface command has never been used on the interface since the
device's startup.
Last 300 seconds input Average input rate over the last 300 seconds in Bps, bps, and pps.
Last 300 seconds output Average output rate over the last 300 seconds in Bps, bps, and pps.
# Display detailed information about Layer 2 interface Ten-GigabitEthernet 1/0/1.
<Sysname> display interface ten-gigabitethernet 1/0/1
Ten-GigabitEthernet1/0/1
Current state: UP
Line protocol state: UP
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000c-1000-1111
Description: Ten-GigabitEthernet1/0/1 Interface
Bandwidth: 10000000kbps
Loopback is not set
Media type is stack wire, Port hardware type is STACK_SFP_PLUS
10Gbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 9216
Allow jumbo frame to pass
Broadcast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Unicast MAX-ratio: 100%
PVID: 1
Mdi type: automdix
Port link-type: access
Tagged Vlan: none
UnTagged Vlan: 1
Port priority: 0
Last clearing of counters: Never
Peak value of input: 0 bytes/sec, at 2016-03-22 06:02:50
Peak value of output: 0 bytes/sec, at 2016-03-22 06:02:50
Last 300 seconds input: 0 packets/sec 0 bytes/sec 0%
Last 300 seconds output: 0 packets/sec 0 bytes/sec 0%
Input (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 0 packets, 0 bytes