R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Command Reference

181
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, S-channel interface view, S-channel
aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
access: Configures the link type of a port as access.
hybrid: Configures the link type of a port as hybrid.
trunk: Configures the link type of a port as trunk.
Usage guidelines
To change the link type of a port from trunk to hybrid or vice versa, first set the link type to access.
• The configuration made in Layer 2 Ethernet interface view applies only to the port.
• The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and
its aggregation member ports.
{ If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
{ If the system fails to apply the configuration to an aggregation member port, it skips the port
and moves to the next member port.
• The configuration made in S-channel interface view or S-channel aggregate interface view applies
only to the interface.
Examples
# Configure Ten-GigabitEthernet 1/0/1 as a trunk port.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port link-type trunk
port trunk permit vlan
Use port trunk permit vlan to assign the trunk ports to the specified VLANs.
Use undo port trunk permit vlan to remove the trunk ports from the specified VLANs.
Syntax
port trunk permit vlan { vlan-id-list | all }
undo port trunk permit vlan { vlan-id-list | all }
Default
A trunk port allows only packets from VLAN 1 to pass through.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, S-channel interface view, S-channel
aggregate interface view