R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Command Reference

229
undo lldp [ agent { nearest-customer | nearest-nontpmr } ] check-change-interval
In Layer 2 aggregate interface view:
lldp agent { nearest-customer | nearest-nontpmr } check-change-interval interval
undo lldp agent { nearest-customer | nearest-nontpmr } check-change-interval
Default
LLDP polling is disabled.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
agent: Specifies an LLDP agent type. If no agent type is specified in Ethernet interface view, the command
enables LLDP polling and sets the polling interval for nearest bridge agents.
nearest-customer: Specifies nearest customer bridge agents.
nearest-nontpmr: Specifies nearest non-TPMR bridge agents.
interval: Sets the LLDP polling interval in the range of 1 to 30 seconds.
Examples
# Enable LLDP polling and set the polling interval to 30 seconds for the nearest customer bridge agents
on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp agent nearest-customer check-change-interval 30
lldp compliance admin-status cdp
Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP.
Use undo lldp compliance admin-status cdp to restore the default.
Syntax
lldp compliance admin-status cdp { disable | txrx }
undo lldp compliance admin-status cdp
Default
CDP-compatible LLDP operates in disable mode.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view
Predefined user roles
network-admin
mdc-admin