R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Command Reference

232
Default
The encapsulation format for LLDPDUs is Ethernet II.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
agent: Specifies an LLDP agent type. If no agent type is specified in Ethernet interface view, the command
configures the LLDPDU encapsulation format for nearest bridge agents.
nearest-customer: Specifies nearest customer bridge agents.
nearest-nontpmr: Specifies nearest non-TPMR bridge agents.
Usage guidelines
LLDP-CDP packets use only SNAP encapsulation.
LLDPDUs carrying the Edge Virtual Bridging (EVB) module TLVs cannot be encapsulated in SNAP.
Examples
# Configure the encapsulation format for LLDPDUs as SNAP on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp encapsulation snap
lldp fast-count
Use lldp fast-count to set the number of LLDPDUs sent each time fast LLDPDU transmission is triggered.
Use undo lldp fast-count to restore the default.
Syntax
lldp fast-count count
undo lldp fast-count
Default
The number is 4.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
count: Sets the number of LLDPDUs sent each time fast LLDPDU transmission is triggered. The value range
is 1 to 8.