R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Command Reference

24
jumboframe enable
Use jumboframe enable to allow jumbo frames within the specified length to pass through.
Use undo jumboframe enable to prevent jumbo frames from passing through.
Syntax
jumboframe enable [ value ]
undo jumboframe enable
Default
The device allows jumbo frames within 9216 bytes to pass through.
Views
Ethernet interface view
Predefined user roles
network-admin
mdc-admin
Parameters
value: Sets the maximum length of Ethernet frames that are allowed to pass through. The value range is
1536 to 9216 bytes.
Usage guidelines
If you set the value argument multiple times, the most recent configuration takes effect.
Examples
# Enable jumbo frames to pass through Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] jumboframe enable
link-delay
Use link-delay to set the physical state change suppression interval on an Ethernet interface.
Use undo link-delay to restore the default.
Syntax
link-delay delay-time [ mode { up | updown } ]
undo link-delay
Default
Each time the physical link of a port goes up or comes down, the interface immediately reports the
change to the CPU.
Views
Ethernet interface view
Predefined user roles
network-admin