R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Command Reference

36
The 10-GE interfaces that are split from a 40-GE interface support the same configuration and attributes
as common 10-GE interfaces, except that they are numbered differently.
After this command is successfully configured, the system prompts you to reboot the card that houses the
40-GE interface. You must reboot the card and then the system deletes the 40-GE interface and creates
the four 10-GE interfaces.
Examples
# Split 40-GE interface FortyGigE 1/0/1 into four 10-GE interfaces.
<System> system-view
[System] interface fortygige 1/0/1
[System-FortyGigE1/0/1] using tengige
The interface FortyGigE1/0/1 will be deleted. Continue? [Y/N]:y
Reboot line card to make the configuration take effect.
Related commands
using fortygige
Layer 2 Ethernet interface commands
broadcast-suppression
Use broadcast-suppression to enable broadcast suppression and set the broadcast suppression
threshold.
Use undo broadcast-suppression to restore the default.
Syntax
broadcast-suppression { ratio | pps max-pps | kbps max-kbps }
undo broadcast-suppression
Default
Ethernet interfaces do not suppress broadcast traffic.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
mdc-admin
Parameters
ratio: Sets the broadcast suppression threshold as a percentage of the maximum interface rate. The value
range for this argument is 0 to 100. The smaller the percentage, the less broadcast traffic is allowed to
pass through.
pps max-pps: Specifies the maximum number of broadcast packets that the interface can forward per
second. The value range for the max-pps argument (in pps) is 0 to 1.4881 × the maximum interface rate.
For example, the value range for this argument is 0 to 1488100 on a GE interface and 0 to 59524000
on a 40-GE interface.