R211x-HP Flexfabric 11900 Layer 2 - LAN Switching Configuration Guide

49
Configuring the global link-aggregation load sharing criteria
Step Command Remarks
1. Enter system view.
system-view N/A
2. Configure the global
link-aggregation load
sharing criteria.
link-aggregation global load-sharing
mode { destination-ip | destination-mac
| destination-port | ingress-port |
source-ip | source-mac | source-port } *
By default, the system
automatically chooses
link-aggregation load sharing
criteria based on packet types.
In system view, the switch supports the following load sharing criteria and combinations:
• Source IP address
• Destination IP address
• Source MAC address
• Destination MAC address
• Source IP address and destination IP address
• Source IP address and source port
• Destination IP address and destination port
• Source IP address, source port, destination IP address, and destination port
• Any combination of ingress port, source MAC address, and destination MAC address
Configuring group-specific load sharing criteria
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 aggregate
interface view.
interface bridge-aggregation
interface-number
N/A
3. Configure the load sharing
criteria for the aggregation
group.
link-aggregation load-sharing mode
{ { destination-ip | destination-mac |
mpls-label1 | mpls-label2 | source-ip
| source-mac } * | flexible }
By default, the load sharing
criteria are the same as the
global load sharing criteria.
In Layer 2 aggregate interface view, the switch supports the following load sharing criteria and
combinations:
• Source IP address
• Destination IP address
• Source MAC address
• Destination MAC address
• Layer 1 MPLS label.
• Destination IP address and source IP address
• Destination MAC address and source MAC address
• Layer 1 MPLS label and Layer 2 MPLS label