R211x-HP Flexfabric 11900 Layer 3 - IP Routing Command Reference

115
Field Descri
p
tion
State
Interface state:
• DOWN—No protocol traffic can be sent or received on the interface.
• Waiting—The interface starts sending and receiving Hello packets and the
router is trying to determine the identity of the (Backup) designated router for
the network.
• P-2-P—The interface will send Hello packets at the interval of HelloInterval,
and try to establish an adjacency with the neighbor.
• DR—The router is the designated router on the network.
• BDR—The router is the backup designated router on the network.
• DROther—The router is a DROther router on the attached network.
Cost Interface cost.
Pri Router priority.
DR DR on the interface's network segment.
BDR BDR on the interface's network segment.
# Display detailed information about VLAN-interface 1.
<Sysname> display ospf interface Vlan-interface 1
OSPF Process 1 with Router ID 192.168.1.1
Interfaces
Interface: 172.16.0.1 (Vlan-interface1)
Cost: 1 State: DR Type: Broadcast MTU: 1500
Priority: 1
Designated router: 172.16.0.1
Backup designated router: 0.0.0.0
Timers: Hello 10, Dead 40, Poll 40, Retransmit 5, Transmit Delay 1
FRR backup: Enabled
Enabled by interface configuration (including secondary IP addresses)
MD5 authentication enabled.
The last key is 3.
The rollover is in progress, 2 neighbor(s) left.
Table 33 Command output
Field Descri
p
tion
Interface Information about the interface, such as the IP address.
Timers OSPF timers: hello, dead, poll, retransmit, and transmit delay.
FRR backup Indicates whether LFA calculation is enabled on an interface.
Enabled by interface
configuration (including
secondary IP addresses)
OSPF is enabled on the interface (including secondary IP addresses).