R211x-HP Flexfabric 11900 Layer 3 - IP Routing Command Reference

1
Basic IP routing commands
The term "interface" in this chapter collectively refers to Layer 3 interfaces, including VLAN interfaces
and Layer 3 Ethernet interfaces. You can set an Ethernet port as a Layer 3 interface by using the port
link-mode route command (see Layer 2—LAN Switching Configuration Guide).
address-family ipv4
Use address-family ipv4 to create a RIB IPv4 address family and enter RIB IPv4 address family view.
Use undo address-family ipv4 to remove a RIB IPv4 address family and all configurations in the view.
Syntax
address-family ipv4
undo address-family ipv4
Default
No RIB IPv4 address family is created.
Views
RIB view
Predefined user roles
network-admin
mdc-admin
Examples
# Create a RIB IPv4 address family and enter RIB IPv4 address family view.
<Sysname> system-view
[Sysname] rib
[Sysname-rib] address-family ipv4
[Sysname-rib-ipv4]
address-family ipv6
Use address-family ipv6 to create a RIB IPv6 address family and enter RIB IPv6 address family view.
Use undo address-family ipv6 to remove a RIB IPv6 address family and all configurations in the view.
Syntax
address-family ipv6
undo address-family ipv6
Default
No RIB IPv6 address family is created.
Views
RIB view