R211x-HP Flexfabric 11900 Layer 3 - IP Routing Command Reference

172
Parameters
ase: Sets a preference for OSPF external routes. Without this keyword, the command sets a preference
for OSPF internal routes.
route-policy route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63
characters, to set a preference for the specified routes.
value: Specifies the preference value in the range of 1 to 255. The smaller the value, the higher the
preference.
Usage guidelines
If multiple routing protocols find routes to the same destination, the router uses the route found by the
protocol with the highest preference.
Examples
# Set a preference of 200 for OSPF external routes.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] preference ase 200
# Use a routing policy to set a preference of 100.
<Sysname> system-view
[Sysname] ip prefix-list test index 10 permit 100.1.1.0 24
[Sysname] route-policy pre permit node 10
[Sysname-route-policy-pre-10] if-match ip address prefix-list test
[Sysname-route-policy-pre-10] quit
[Sysname] ospf 100
[Sysname-ospf-100] preference route-policy pre 100
prefix-priority
Use prefix-priority to enable prefix prioritization.
Use undo prefix-priority to disable prefix prioritization.
Syntax
prefix-priority route-policy route-policy-name
undo prefix-priority
Default
Prefix prioritization is disabled.
Views
OSPF view
Predefined user roles
network-admin
mdc-admin
Parameters
route-policy route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63
characters, to set a priority for the specified route prefixes.