R211x-HP Flexfabric 11900 Layer 3 - IP Routing Command Reference

179
lsdb-overflow: Specifies LSDB overflow notifications.
neighbor-state-change: Specifies notifications about neighbor state change.
nssatranslator-status-change: Specifies notifications about NSSA translator state change.
retransmit: Specifies notifications about packets that are received and forwarded on an interface.
virt-authentication-failure: Specifies notifications about authentication failures on a virtual interface.
virt-bad-packet: Specifies notifications about error messages received on a virtual interface.
virt-config-error: Specifies notifications about error configuration of a virtual interface.
virt-retransmit: Specifies notifications about packets that are received and forwarded on a virtual
interface.
virtgrhelper-status-change: Specifies notifications about neighbor GR helper state changes of a virtual
interface.
virtif-state-change: Specifies notifications about virtual interface state change.
virtneighbor-state-change: Specifies notifications about the neighbor state change of a virtual interface.
Examples
# Disable SNMP notifications for OSPF.
<Sysname> system-view
[Sysname] undo snmp-agent trap enable ospf
snmp trap rate-limit
Use snmp trap rate-limit to configure the maximum number of output SNMP notifications within a
specified time interval.
Use undo snmp trap rate-limit to restore the default.
Syntax
snmp trap rate-limit interval trap-interval count trap-number
undo snmp trap rate-limit
Default
OSPF outputs up to seven SNMP notifications within 10 seconds.
Views
OSPF view
Predefined user roles
network-admin
mdc-admin
Parameters
trap-interval: Specifies the SNMP notification output interval in the range of 1 to 60 seconds.
trap-number: Specifies the number of output SNMP notifications in a specific time, in the range of 0 to
300.
Examples
# Configure OSPF to output up to 10 SNMP notifications within 5 seconds.