R211x-HP Flexfabric 11900 Layer 3 - IP Routing Command Reference

201
Field Descri
p
tion
ATT/P/OL
• ATT—Attach bit.
• P—Partition bit.
• OL—Overload bit.
1 means the LSP bit is set and 0 means the LSP bit is not set.
Source System ID of the originating router.
NLPID Network layer protocol the originating router runs.
Area address Area address of the originating router.
IPv4 address IP address of the originating router's IS-IS interface.
IPv6 address IPv6 address of the originating router's IS-ISv6 interface.
NBR ID Neighbor ID of the originating router.
IP-Internal Internal IP address and mask of the originating router.
IP-External External IP address and mask of the originating router.
IP-Extended Extended IP address and mask of the originating router.
COST Cost.
Auth Authentication information of the originating router.
IPV6 Internal IPv6 address and prefix of the originating router.
IPV6-Ext External IPv6 address and prefix of the originating router.
display isis name-table
Use display isis name-table to display the host name to system ID mapping table.
Syntax
display isis name-table [ process-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
process-id: Displays the host name to system ID mapping table for an IS-IS process specified by its ID in
the range of 1 to 65535. Without this argument, the command displays the host name to system ID
mapping table for all IS-IS processes.
Examples
# Configure a name RUTA for the local IS system.
<Sysname> system-view