R211x-HP Flexfabric 11900 Layer 3 - IP Routing Command Reference

500
Use undo stub to restore the default.
Syntax
stub [ default-route-advertise-always | no-summary ] *
undo stub
Default
No area is configured as a stub area.
Views
OSPFv3 area view
Predefined user roles
network-admin
mdc-admin
Parameters
default-route-advertise-always: Enables the ABR to always advertise the default route.
no-summary: Enables the ABR of a stub area to advertise only a default route in an Inter-Area-Prefix-LSA
into the stub area. No AS-external-LSA, Inter-Area-Prefix-LSA, or other Inter-Area-Router-LSA is advertised
in the area. The stub area of this kind is also known as a "totally stub area."
Usage guidelines
To remove the no-summary configuration on an ABR, execute the stub command again to overwrite it.
To configure an area as a stub area, issue the stub command on all routers attached to the area.
Examples
# Configure OSPFv3 area 1 as a stub area.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 1
[Sysname-ospfv3-1-area-0.0.0.1] stub
Related commands
default cost (OSPFv3 area view)
transmit-pacing
Use transmit-pacing to configure the maximum number of LSU packets that can be sent at the specified
interval.
Use undo transmit-pacing to restore the default.
Syntax
transmit-pacing interval interval count count
undo transmit-pacing
Default
An OSPFv3 interface sends a maximum of three LSU packets every 20 milliseconds.