R211x-HP Flexfabric 11900 Layer 3 - IP Routing Command Reference

530
Field Description
node 0 deny/node 2 permit Match mode of the node, permit or deny.
if-match acl Match packets against the ACL.
apply next-hop Specify a next hop for permitted packets.
Matched: 0 Number of successful matches on the node.
Total matched Total number of successful matches on all nodes.
Related commands
reset ipv6 policy-based-route statistics
display ipv6 policy-based-route setup
Use display ipv6 policy-based-route setup to display IPv6 PBR configuration.
Syntax
display ipv6 policy-based-route setup
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Examples
# Display IPv6 PBR configuration.
<Sysname> display ipv6 policy-based-route setup
Policy Name Interface Name
pr01 Vlan-interface 1
Table 134 Command output
Field Description
policy Name Policy name.
Interface Name Interface where the policy is applied.
Related commands
ipv6 policy-based-route (interface view)
if-match acl
Use if-match acl to configure an ACL match criterion.
Use undo if-match acl to remove the ACL match criterion.