R211x-HP Flexfabric 11900 Layer 3 - IP Routing Command Reference

86
Examples
# Disable automatic RIPv2 route summarization.
<Sysname> system-view
[Sysname] rip
[Sysname-rip-1] undo summary
Related commands
• rip summary-address
• rip version
timers
Use timers to configure RIP timers.
Use undo timers to restore the default.
Syntax
timers { garbage-collect garbage-collect-value | suppress suppress-value | timeout timeout-value |
update update-value } *
undo timers { garbage-collect | suppress | timeout | update } *
Default
The garbage-collect timer is 120 seconds, the suppress timer is 120 seconds, the timeout timer is 180
seconds, and the update timer is 30 seconds.
Views
RIP view
Predefined user roles
network-admin
mdc-admin
Parameters
garbage-collect-value: Specifies the garbage-collect timer in the range of 1 to 3600 seconds.
suppress-value: Specifies the suppress timer in the range of 0 to 3600 seconds.
timeout-value: Specifies the timeout timer in the range of 1 to 3600 seconds.
update-value: Specifies the update timer in the range of 1 to 3600 seconds.
Usage guidelines
RIP uses the following timers:
• Update timer—Specifies the interval between routing updates.
• Timeout timer—Specifies the route aging time. If no update for a route is received before the timer
expires, RIP sets the metric of the route to 16.
• Suppress timer—Specifies how long a RIP route stays in suppressed state. When the metric of a
route becomes 16, the route enters the suppressed state. If RIP receives an update for the route from
the same neighbor and the route in the update has a metric less than 16, RIP uses the route to
replace the suppressed route.