R211x-HP Flexfabric 11900 Layer 3 - IP Routing Configuration Guide

289
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Apply a policy locally.
ip local policy-based-route
policy-name
By default, no policy is locally
applied.
Configuring interface PBR
Configure PBR by applying a policy to an interface. PBR uses the policy to guide the forwarding of
packets received on the interface. The specified policy must already exist. Otherwise, the interface PBR
configuration fails.
You can apply only one policy to an interface. Before you apply a new policy, you must first remove the
current policy from the interface.
You can apply a policy to multiple interfaces.
To configure interface PBR:
Ste
p
Command Remarks
1. Enter system
view.
system-view N/A
2. Enter interface
view.
interface interface-type interface-number N/A
3. Apply a policy
to the interface.
ip policy-based-route policy-name
By default, no policy is applied to the
interface.
Displaying and maintaining PBR
Execute display commands in any view and reset commands in user view.
Task Command
Display PBR policy information. display ip policy-based-route [ policy policy-name ]
Display PBR configuration. display ip policy-based-route setup
Display local PBR configuration and statistics (in
standalone mode).
display ip policy-based-route local [ slot slot-number ]
Display local PBR configuration and statistics (in
IRF mode).
display ip policy-based-route local [ chassis chassis-number
slot slot-number ]
Display interface PBR configuration and
statistics (in standalone mode).
display ip policy-based-route interface interface-type
interface-number [ slot slot-number ]
Display interface PBR configuration and
statistics (in IRF mode).
display ip policy-based-route interface interface-type
interface-number [ chassis chassis-number slot slot-number ]
Clear PBR statistics. reset ip policy-based-route statistics [ policy policy-name ]