R211x-HP Flexfabric 11900 Layer 3 - IP Routing Configuration Guide

291

[SwitchB] vlan 10

[SwitchB-vlan10] quit

# Configure the IP address of VLAN-interface 10.

[SwitchB] interface vlan-interface 10

[SwitchB-Vlan-interface10] ip address 1.1.2.2 24

3. Configure Switch C:

# Create VLAN 20.

<SwitchC> system-view

[SwitchC] vlan 20

[SwitchC-vlan20] quit

# Configure the IP address of VLAN-interface 20.

[SwitchC] interface vlan-interface 20

[SwitchC-Vlan-interface20] ip address 1.1.3.2 24

Verifying the configuration

# Telnet to Switch B on Switch A. The operation succeeds.

# Telnet to Switch C on Switch A. The operation fails.

# Ping Switch C from Switch A. The operation succeeds.

Telnet uses TCP and ping uses ICMP. The preceding results show that all TCP packets sent from Switch A

are forwarded to the next hop 1.1.2.2, and other packets are forwarded through VLAN-interface 20. The

local PBR configuration is effective.

Packet type-based interface PBR configuration example

Network requirements

As shown in Figure 73, configure PBR on Switch A to forward all TCP packets received on VLAN-interface

11 to the next hop 1.1.2.2. Switch A forwards other packets according to the routing table.