R211x-HP Flexfabric 11900 Layer 3 - IP Services Command Reference

169
UDP helper commands
The term "interface" in this chapter collectively refers to VLAN interfaces and Layer 3 Ethernet interfaces.
You can set an Ethernet port as a Layer 3 interface by using the port link-mode route command (see
Layer 2—LAN Switching Configuration Guide).
display udp-helper interface
Use display udp-helper interface to display information about packets forwarded by UDP helper on an
interface.
Syntax
display udp-helper interface interface-type interface-number
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
This command shows information about the destination server and the number of UDP packets
forwarded to the destination server.
Examples
# Display information about packets forwarded by UDP helper on VLAN-interface 1.
<Sysname> display udp-helper interface vlan-interface 1
Interface Server address Packets sent
Vlan-interface1 192.1.1.2 0
Table 36 Command output
Field Descri
p
tion
Interface Interface name.
Server address Destination server to which UDP packets are forwarded.
Packets sent Number of packets forwarded to the destination server.
Related commands
• reset udp-helper statistics