R211x-HP Flexfabric 11900 Layer 3 - IP Services Command Reference

284
Internet protocol processing: disabled
Tunnel source unknown, destination unknown
Tunnel encapsulation-limit is disabled
Tunnel TTL 255
Tunnel protocol/transport IPv6
Last clearing of counters: 13:49:20 Thu 06/13/2013
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
Table 61 Command output
Field Descri
p
tion
Tunnel1 Information about the tunnel interface Tunnel1.
Current state
State of the tunnel interface:
• Administratively DOWN—The interface has been shut down by the
shutdown command.
• DOWN—The interface is administratively up but its physical state is
down.
• UP—Both the administrative and physical states of the interface are
up.
Line protocol state
Link layer protocol state of the tunnel interface. The value is determined
by the parameter negotiation on the link layer.
• UP—The protocol state of the interface is up.
• UP (spoofing)—The link protocol state of the interface is up, but the
link is temporarily set up on demand or does not exist. This attribute
is available for null interfaces and loopback interfaces.
• DOWN—The protocol state of the interface is down.
Description Description of the tunnel interface.
Bandwidth Intended bandwidth for the tunnel interface.
Maximum Transmit Unit MTU of the tunnel interface.
Internet Address
IP address of the tunnel interface.
If no IP address is assigned to the interface, this field displays Internet
protocol processing: disabled, and the tunnel interface cannot process
packets.
Primary indicates it is the primary IP address of the interface.
Tunnel source Source address of the tunnel.
destination Destination address of the tunnel.
Tunnel encapsulation-limit is disabled Tunnel nested encapsulation is not supported.
Tunnel TTL TTL of tunneled packets.