R211x-HP Flexfabric 11900 MPLS Command Reference

284
peer ip-address [ pw-id pw-id ] [ no-split-horizon | pw-class class-name | tunnel-policy
tunnel-policy-name ] *
undo peer ip-address pw-id pw-id
VSI static configuration view:
peer ip-address [ pw-id pw-id ] [ in-label label-value out-label label-value [ no-split-horizon | pw-class
class-name | tunnel-policy tunnel-policy-name ] * ]
undo peer ip-address pw-id pw-id
Default
No PW is configured for VPLS.
Views
VSI LDP signaling view, VSI static configuration view
Predefined user roles
network-admin
mdc-admin
Parameters
ip-address: Specifies the LSR ID of the peer PE.
pw-id pw-id: Specifies a PW ID for the PW, in the range of 1 to 4294967295. If no PW ID is specified,
the default PW ID is used (specified by the default-pw-id command).
in-label label-value: Specifies the incoming label of the PW, in the range of 16 to 1023.
out-label label-value: Specifies the outgoing label of the PW, in the range of 16 to 1023.
no-split-horizon: Disable split horizon forwarding for the PW. By default, a PW must use the split horizon
forwarding scheme to forward packets.
pw-class class-name: Specifies a PW class by its name, a case-sensitive string of 1 to 19 characters. If no
PW class is specified, the PW type is VLAN and the PW does not support control word.
tunnel-policy tunnel-policy-name: Specifies a tunnel policy by its name, a case-insensitive string of 1 to
19 characters. If no tunnel policy is specified, the PW uses the default tunnel policy.
Usage guidelines
To create a static PW, you must specify the incoming and outgoing labels. To enter VSI static PW view of
an existing static PW, you do not need to specify the incoming and outgoing labels.
A PW ID identifies a PW between two PEs. The PW ID for a PW must be the same on the PEs at the ends
of the PW.
On a PE, the LSR ID of the peer PE and the PW ID uniquely identify a PW, and must not be both the same
as those of any VPLS PW or cross-connect PW.
If you have configured a default PW ID with the default-pw-id command in VSI view, you can use the
default PW ID without providing a PW ID in the peer command. If no default PW ID is configured, you
must provide a PW ID in the peer command.
Examples
# Configure an LDP PW for the VSI vpn1 and enter VSI LDP PW view: specify the peer PE address as
4.4.4.4, set the PW ID to 200, and disable split horizon forwarding for the PW.
<Sysname> system-view