R211x-HP Flexfabric 11900 MPLS Command Reference

Usage guidelines

After failing to establish an MPLS TE tunnel, the tunnel ingress node waits for the tunnel setup retry

interval, and then try to set up the tunnel again until the tunnel is established successfully or until the

number of tunnel setup attempts reaches the maximum (configured by the mpls te retry command). If the

tunnel cannot be established when the number of attempts reaches the maximum, the ingress waits for a

longer period and then repeats the previous process.

Examples

# Configure the setup retry interval as 20 seconds for tunnel 0.

<Sysname> system-view

[Sysname] interface tunnel 0 mode mpls-te

[Sysname-Tunnel0] mpls te timer retry 20

Related commands

• display mpls te tunnel-interface

• mpls te retry