R211x-HP Flexfabric 11900 MPLS Configuration Guide
6
• Configure link layer protocols to ensure connectivity at the link layer.
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring
nodes.Configure static routes or an IGP protocol to ensure IP connectivity among LSRs.To enable
MPLS:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure an LSR ID for the local
node.
mpls lsr-id lsr-id
By default, no LSR ID is configured.
An LSR ID must be unique in an MPLS
network and in IP address format. HP
recommends that you use the IP
address of a loopback interface as
an LSR ID.
3. Enter the view of the interface
that needs to perform MPLS
forwarding.
interface interface-type
interface-number
N/A
4. Enable MPLS for the interface.
mpls enable
By default, MPLS is disabled on an
interface.
Configuring MPLS MTU
MPLS inserts the label stack between the link layer header and network layer header of each packet. To
make sure the size of MPLS labeled packets is smaller than the MTU of an interface, configure an MPLS
MTU on the interface.
MPLS compares each MPLS packet against the interface MPLS MTU. When the packet exceeds the MPLS
MTU:
• If fragmentation is allowed, MPLS removes the label stack from the packet, fragments the IP packet
(the length of a fragment is the MPLS MTU minus the length of the label stack), adds the label stack
to each fragment, and forwards the fragments.
• If fragmentation is not allowed, the LSR drops the packet.
To configure an MPLS MTU for an interface:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an MPLS MTU for
the interface.
mpls mtu value
By default, no MPLS MTU is
configured on an interface.
The following applies when an interface handles MPLS packets:
• MPLS packets carrying L2VPN or IPv6 packets are always forwarded by an interface, even if the
length of the MPLS packets exceeds the MPLS MTU of the interface. Whether the forwarding can
succeed depends on the actual forwarding capacity of the interface.
• If the MPLS MTU of an interface is greater than the MTU of the interface, data forwarding might fail
on the interface.