R211x-HP Flexfabric 11900 MPLS Configuration Guide

138
Task Command Remarks
Display BGP VPNv4 route
statistics.
display bgp routing-table vpnv4 statistics Available in any view.
Display BGP VPNv4 address
family update group information.
display bgp update-group vpnv4
[ vpn-instance vpn-instance-name ]
[ ip-address ]
Available in any view.
Display OSPF sham link
information (in standalone mode).
display ospf [ process-id ] sham-link [ area
area-id ] [ standby slot slot-number ]
Available in any view.
Display OSPF sham link
information (in IRF mode).
display ospf [ process-id ] sham-link [ area
area-id ] [ standby chassis chassis-number
slot slot-number ]
Available in any view.
MPLS L3VPN configuration examples
Configuring basic MPLS L3VPN
Network requirements
CE 1 and CE 3 belong to VPN 1. CE 2 and CE 4 belong to VPN 2.
VPN 1 uses route target attribute 111:1. VPN 2 uses route target attribute 222:2. Users of different VPNs
cannot access each other.
EBGP is used to exchange VPN routing information between CE and PE.
PEs use OSPF to communicate with each other and use MP-IBGP to exchange VPN routing information.
Figure 47 Network diagram
Device Interface IP address Device Interface IP address
CE 1 Vlan-int11 10.1.1.1/24 P Loop0 2.2.2.9/32
PE 1 Loop0 1.1.1.9/32 Vlan-int12 172.2.1.1/24
Vlan-int11 10.1.1.2/24 Vlan-int13 172.1.1.2/24