R211x-HP Flexfabric 11900 MPLS Configuration Guide

210
Ste
p
Command Remarks
4. Create and enter BGP IPv6
unicast family view.
address-family ipv6 [ unicast ] N/A
5. Enable IPv6 unicast route
exchange with the specified
peer or peer group.
peer { group-name |
ipv6-address } enable
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
6. (Optional.) Configure route
redistribution.
import-route protocol
[ process-id [ med med-value |
route-policy route-policy-name ]
* ]
A CE must redistribute its routes
to the PE so the PE can advertise
them to the peer CE.
Configuring routing between PEs
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Configure the remote PE as
the peer.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
configured.
4. Specify the source interface
for route update packets sent
to the specified peer.
peer { group-name | ip-address }
connect-interface interface-type
interface-number
By default, BGP uses the outbound
interface of the best route destined
to the BGP peer as the source
interface.
5. Enter BGP-VPNv6 address
family view.
address-family vpnv6 N/A
6. Enable BGP-VPNv6 route
exchange with the specified
peer.
peer { group-name | ip-address }
enable
By default, BGP does not exchange
BGP-VPNv6 routes with any peer.
Configuring BGP VPNv6 route control
BGP VPNv6 route control is configured similarly with BGP route control, except that it is configured in
BGP-VPNv6 address family view. For detailed information about BGP route control, see Layer 3—IP
Routing Configuration Guide.
To configure BGP VPNv6 route control:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter BGP-VPNv6 address
family view.
address-family vpnv6 N/A
4. (Optional.) Configure filtering
of advertised routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
export [ protocol process-id ]
By default, the PE does not filter
advertised routes.