R211x-HP Flexfabric 11900 MPLS Configuration Guide

251
Ste
p
Command Remarks
9. Create a cross-connect and
enter auto-discovery
cross-connect view.
connection remote-site-id
remote-site-id
By default, no cross-connect is
created.
After you execute this command, a
PW to the specified remote site is
created and is bound to the
cross-connect.
10. (Optional.) Reference a tunnel
policy.
tunnel-policy tunnel-policy-name
By default, no tunnel policy is
referenced.
Binding an AC to a cross-connect
This task is mutually exclusive with Ethernet link aggregation. If an Ethernet interface has been added to
a link aggregation group, you cannot bind a service instance on the interface to a cross-connect, and
vice versa.
After you bind a service instance on an interface to a cross-connect, packets that are received from the
interface and meet the match criteria of the service instance are forwarded to the PW or another AC
bound to the cross-connect. A service instance can match all packets, tagged packets, or untagged
packets.
To bind a service instance to a non-BGP cross-connect:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter cross-connect group
view.
xconnect-group group-name N/A
3. Enter cross-connect view.
connection connection-name N/A
4. Bind the service instance on
the interface to the
cross-connect.
ac interface interface-type
interface-number service-instance
instance-id [ access-mode
{ ethernet | vlan } ]
By default, no service instance is
bound to the cross-connect.
To bind a service instance to a BGP cross-connect:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter cross-connect group
view.
xconnect-group group-name N/A
3. Enter cross-connect group
auto-discovery view.
auto-discovery bgp N/A
4. Enter site view.
site site-id [ range range-value ]
[ default-offset default-offset-value ]
N/A
5. Enter auto-discovery
cross-connect view.
connection remote-site-id
remote-site-id
N/A