R211x-HP Flexfabric 11900 MPLS Configuration Guide

254
Task Command
Display BGP L2VPN peer group
information.
display bgp group l2vpn [ group-name ]
Display L2VPN label block information
maintained by BGP.
display bgp l2vpn signaling [ peer ip-address { advertised |
received } [ statistics ] | route-distinguisher route-distinguisher
[ site-id site-id [ label-offset label-offset [ advertise-info ] ] ] |
statistics ]
Display BGP L2VPN peer information.
display bgp peer l2vpn [ group-name log-info | ip-address
{ log-info | verbose } | verbose ]
Display BGP L2VPN update group
information.
display bgp update-group l2vpn [ ip-address ]
Reset BGP sessions for L2VPN.
reset bgp { as-number | ip-address | all | external | group
group-name | internal } l2vpn
MPLS L2VPN configuration examples
Configuring a static PW
Network requirements
Create a static PW between PE 1 and PE 2 over the backbone so CE 1 and CE 2 can communicate
within VLAN 10.
Figure 68 Network diagram
Device Interface IP address Device Interface IP address
PE 1 Loop0 192.2.2.2/32 P Loop0 192.4.4.4/32
Vlan-int20 10.1.1.1/24 Vlan-int30 10.2.2.2/24
PE 2 Loop0 192.3.3.3/32 Vlan-int20 10.1.1.2/24
Vlan-int30 10.2.2.1/24
Configuration procedure
Before you perform the following configurations, configure VLANs and add ports to VLANs on switches.
1. Configure CE 1.
<CE1> system-view