R211x-HP Flexfabric 11900 MPLS Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP FlexFabric 11000 Switch Products

# Configure Switch B.

[SwitchB] mpls lsr-id 2.2.2.9

[SwitchB] mpls te

[SwitchB-te] quit

[SwitchB] rsvp

[SwitchB-rsvp] quit

[SwitchB] interface vlan-interface 1

[SwitchB-Vlan-interface1] mpls enable

[SwitchB-Vlan-interface1] mpls te enable

[SwitchB-Vlan-interface1] rsvp enable

[SwitchB-Vlan-interface1] quit

[SwitchB] interface vlan-interface 2

[SwitchB-Vlan-interface2] mpls enable

[SwitchB-Vlan-interface2] mpls te enable

[SwitchB-Vlan-interface2] rsvp enable

[SwitchB-Vlan-interface2] quit

# Configure Switch C.

[SwitchC] mpls lsr-id 3.3.3.9

[SwitchC] mpls te

[SwitchC-te] quit

[SwitchC] rsvp

[SwitchC-rsvp] quit

[SwitchC] interface vlan-interface 3

[SwitchC-Vlan-interface3] mpls enable

[SwitchC-Vlan-interface3] mpls te enable

[SwitchC-Vlan-interface3] rsvp enable

[SwitchC-Vlan-interface3] quit

[SwitchC] interface vlan-interface 2

[SwitchC-Vlan-interface2] mpls enable

[SwitchC-Vlan-interface2] mpls te enable

[SwitchC-Vlan-interface2] rsvp enable

[SwitchC-Vlan-interface2] quit

# Configure Switch D.

[SwitchD] mpls lsr-id 4.4.4.9

[SwitchD] mpls te

[SwitchD-te] quit

[SwitchD] rsvp

[SwitchD-rsvp] quit

[SwitchD] interface vlan-interface 3

[SwitchD-Vlan-interface3] mpls enable

[SwitchD-Vlan-interface3] mpls te enable

[SwitchD-Vlan-interface3] rsvp enable

[SwitchD-Vlan-interface3] quit

4. On Switch A, configure MPLS TE tunnel interface Tunnel 1, specify the tunnel destination address

as the LSR ID of Switch D, and configure MPLS TE to use RSVP-TE to establish the tunnel.

[SwitchA] interface tunnel 1 mode mpls-te

[SwitchA-Tunnel1] ip address 7.1.1.1 255.255.255.0

[SwitchA-Tunnel1] destination 4.4.4.9