R211x-HP Flexfabric 11900 MPLS Configuration Guide

[SwitchD] rsvp

[SwitchD-rsvp] quit

[SwitchD] interface vlan-interface 3

[SwitchD-Vlan-interface3] mpls enable

[SwitchD-Vlan-interface3] mpls te enable

[SwitchD-Vlan-interface3] rsvp enable

[SwitchD-Vlan-interface3] quit

4. Configure a co-routed bidirectional MPLS TE tunnel:

# Configure Switch A as the active end of the co-routed bidirectional tunnel.

[SwitchA] interface tunnel 1 mode mpls-te

[SwitchA-Tunnel1] ip address 7.1.1.1 255.255.255.0

[SwitchA-Tunnel1] destination 4.4.4.9

[SwitchA-Tunnel1] mpls te signaling rsvp-te

[SwitchA-Tunnel1] mpls te resv-style ff

[SwitchA-Tunnel1] mpls te bidirectional co-routed active

[SwitchA-Tunnel1] quit

# Configure Switch D as the passive end of the co-routed bidirectional tunnel.

[SwitchD] interface tunnel 4 mode mpls-te

[SwitchD-Tunnel4] ip address 8.1.1.1 255.255.255.0

[SwitchD-Tunnel4] destination 1.1.1.9

[SwitchD-Tunnel4] mpls te signaling rsvp-te

[SwitchD-Tunnel4] mpls te resv-style ff

[SwitchD-Tunnel4] mpls te bidirectional co-routed passive reverse-lsp lsr-id 1.1.1.9

tunnel-id 1

[SwitchD-Tunnel4] quit

Verifying the configuration

# Execute the display interface tunnel command on Switch A. The output shows that the tunnel interface

is up.

[SwitchA] display interface tunnel

Tunnel1 current state: UP

Line protocol current state: UP

Description: Tunnel1 Interface

The Maximum Transmit Unit is 64000

Internet Address is 7.1.1.1/24 Primary

Tunnel source unknown, destination 4.4.4.9

Tunnel bandwidth 64 (kbps)

Tunnel protocol/transport CR_LSP

Last clearing of counters: Never

Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec

Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 drops

0 packets output, 0 bytes, 0 drops

# Execute the display mpls te tunnel-interface command on Switch A to display detailed information

about the MPLS TE tunnel.

[SwitchA] display mpls te tunnel-interface

Tunnel Name : Tunnel 4