R211x-HP Flexfabric 11900 Network Management and Monitoring Command Reference

119
Default
The SNMP agent uses the IP address of the outgoing routed interface as the source IP address of
notifications.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
inform: Specifies informs.
trap: Specifies traps.
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
The snmp-agent source command enables the SNMP agent to use the primary IP address of an interface
as the source IP address in all its SNMP informs or traps, regardless of their outgoing interfaces. An NMS
can use this IP address to filter all the informs or traps sent by the SNMP agent.
Make sure the specified interface has been created and assigned a valid IP address. The configuration
will fail if the interface has not been created and will take effect only after a valid IP address is assigned
to the specified interface.
Examples
# Configure the primary IP address of Ten-GigabitEthernet 1/0/1 as the source address of SNMP traps.
<Sysname> system-view
[Sysname] snmp-agent trap source ten-gigabitethernet 1/0/1
# Configure the primary IP address of Ten-GigabitEthernet 1/0/2 as the source address of SNMP
informs.
<Sysname> system-view
[Sysname] snmp-agent inform source ten-gigabitethernet 1/0/2
Related commands
• display snmp-agent community
• snmp-agent target-host
• snmp-agent trap enable
snmp-agent sys-info contact
Use snmp-agent sys-info contact to configure the system contact.
Use undo snmp-agent sys-info contact to restore the default contact.
Syntax
snmp-agent sys-info contact sys-contact
undo snmp-agent sys-info contact