R211x-HP Flexfabric 11900 Network Management and Monitoring Command Reference

129
# Add the user userv2c in the SNMPv2c group readCom so only the NMS at 1.1.1.1 can use the protocol
SNMPv2c and read-only community name userv2c to access the device.
<Sysname> system-view
[Sysname] acl number 2001
[Sysname-acl-basic-2001] rule permit source 1.1.1.1 0.0.0.0
[Sysname-acl-basic-2001] rule deny source any
[Sysname-acl-basic-2001] quit
[Sysname] snmp-agent sys-info version v2c
[Sysname] snmp-agent group v2c readCom
[Sysname] snmp-agent usm-user v2c userv2c readCom acl 2001
Related commands
• display snmp-agent community
• snmp-agent community
• snmp-agent group
snmp-agent usm-user v3
Use snmp-agent usm-user v3 to add a user to an SNMPv3 group.
Use undo snmp-agent usm-user v3 to delete a user from an SNMPv3 group.
Syntax
In non-FIPS mode:
snmp-agent usm-user v3 user-name group-name [ remote { ip-address | ipv6 ipv6-address }
[ vpn-instance vpn-instance-name ] ] [ { cipher | simple } authentication-mode { md5 | sha }
auth-password [ privacy-mode { aes128 | des56 } priv-password ] ] [ acl acl-number | acl ipv6
ipv6-acl-number ] *
undo snmp-agent usm-user v3 user-name group-name { local | engineid engineid-string | remote
{ ip-address | ipv6 ipv6-address } [ vpn-instance vpn-instance-name ] }
In FIPS mode:
snmp-agent usm-user v3 user-name group-name [ remote { ip-address | ipv6 ipv6-address }
[ vpn
-instance vpn-instance-name ] ] [ { cipher | simple } authentication-mode sha auth-password
[ privacy-mode aes128 priv-password ] ] [ acl acl-number | acl ipv6 ipv6-acl-number ] *
undo snmp-agent usm-user v3 user-name group-name { local | engineid engineid-string | remote
{ ip-address | ipv6 ipv6-address } [ vpn-instance vpn-instance-name ] }
Default
No SNMPv3 users have been configured.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
user-name: Specifies an SNMPv3 username, a case-sensitive string of 1 to 32 characters.