R211x-HP Flexfabric 11900 Network Management and Monitoring Command Reference

226
Port mirroring commands
The port mirroring commands are available on both Layer 2 and Layer 3 Ethernet interfaces. The term
"interface" in this chapter collectively refers to these two types of interfaces. You can use the port
link-mode command to configure an Ethernet port as a Layer 2 or Layer 3 interface (see Layer 2—LAN
Switching Configuration Guide).
display mirroring-group
Use display mirroring-group to display mirroring group information.
Syntax
display mirroring-group { group-id | all | local | remote-destination | remote-source }
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
group-id: Displays information about a mirroring group specified by its number in the range of 1 to 4.
all: Displays information about all mirroring groups.
local: Displays local mirroring group information.
remote-destination: Displays remote destination group information.
remote-source: Displays remote source group information.
Usage guidelines
Mirroring group information includes the type, status, and content of a mirroring group, and is sorted by
mirroring group number.
Examples
# Display information about all mirroring groups.
<Sysname> display mirroring-group all
Mirroring group 1:
Type: Local
Status: Active
Mirroring port:
Ten-GigabitEthernet1/0/1 Inbound
Ten-GigabitEthernet1/0/2 Both
Mirroring CPU:
Slot 1, 2, 3 Both