R211x-HP Flexfabric 11900 Network Management and Monitoring Command Reference

235
undo mirroring-group group-id reflector-port
Default
No reflector port is configured for a mirroring group, and a port does not serve as the reflector port for
a mirroring group.
Views
System view, interface view
Predefined user roles
network-admin
mdc-admin
Parameters
group-id: Specifies the number of a mirroring group, in the range of 1 to 4. The mirroring group specified
by group-id must already exist.
interface-type interface-number: Specifies a port to be configured as the reflector port by its type and
number.
Usage guidelines
You can configure reflector ports only for remote source groups but not for local mirroring groups or
remote destination groups.
Select a port not in use on the device to be configured as the reflector port. Do not connect a cable to the
reflector port.
When a port is configured as a reflector port, all existing configuration of the port is cleared. You cannot
configure other features on the reflector port.
You cannot change the duplex mode and port rate for a port after the port is configured as a reflector
port.
Examples
# Create remote source group 1, and configure port Ten-GigabitEthernet 1/0/1 as its reflector port in
system view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 reflector-port ten-gigabitethernet 1/0/1
This operation may delete all settings made on the interface. Continue? [Y/N]: y
# Create remote source group 2, and configure port Ten-GigabitEthernet 1/0/2 as its reflector port in
interface view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] interface ten-gigabitethernet 1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] mirroring-group 2 reflector-port
This operation may delete all settings made on the interface. Continue? [Y/N]: y
Related commands
mirroring-group