Manualshelf

R211x-HP Flexfabric 11900 Network Management and Monitoring Command Reference

ManualsBrandsHP ManualsNetwork HardwareHP FlexFabric 11000 Switch Products
919293949596979899100
85
Usage guidelines
To view the debug information on the console, execute the terminal debugging command, enable the
information center (enabled by default), and use a debugging command to enable the related
debugging.
To view debug information on the current terminal, execute the terminal monitor and terminal debugging
commands, enable the information center (enabled by default), and use a debugging command to
enable the related debugging.
The configuration of this command is only valid for the current connection between the terminal and the
device. If a new connection is established, the default is restored.
You can also execute the terminal logging level 7 command to enable the display of debug information
on the current terminal. However, this command also enables the display of all other log information.
Examples
# Enable the display of debug information on the current terminal.
<Sysname> terminal debugging
The current terminal is enabled to display debugging information.
Related commands
• terminal logging level
• terminal monitor
terminal logging level
Use terminal logging level to set the lowest level of the logs that can be output to the current terminal.
Use undo terminal logging level to restore the default.
Syntax
terminal logging level severity
undo terminal logging level
Default
The lowest level of the logs that can be output to the console and the monitor terminal is 6 (Informational).
Views
User view
Predefined user roles
network-admin
mdc-admin
Parameters
severity: Specifies the lowest level of the logs that can be output to the current terminal, in the range of 0
to 7.
Usage guidelines
If you specify the lowest level of the logs that can be output to the current terminal, the device outputs the
logs with a severity level higher than or equal to the specified level. For example, if you set the lowest level
of the logs that can be output to the current terminal to 6 (informational), logs with a severity value from
0 to 6 will be output.