R211x-HP Flexfabric 11900 Network Management and Monitoring Configuration Guide

163
Configuration procedure
To configure source ports in system view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure source ports for the
specified local mirroring
group.
mirroring-group group-id
mirroring-port interface-list { both |
inbound | outbound }
By default, no source port is
configured for a local mirroring
group.
To configure source ports in interface view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the port as a source
port for the specified local
mirroring group.
mirroring-group group-id
mirroring-port { both | inbound |
outbound }
By default, a port does not serve as
a source port for any local
mirroring group.
Configuring source CPUs for a local mirroring group
On the source device, configure the CPUs of the cards to be monitored as the source CPUs. The
destination device does not support source CPU configuration.
A mirroring group can contain multiple source CPUs.
To configure source CPUs for a local mirroring group:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure source CPUs for the
specified local mirroring
group.
• In standalone mode:
mirroring-group group-id
mirroring-cpu slot
slot-number-list { both |
inbound | outbound }
• In IRF mode:
mirroring-group group-id
mirroring-cpu chassis
chassis-number slot
slot-number-list { both |
inbound | outbound }
By default, no source CPU is
configured for a local mirroring
group.