R211x-HP Flexfabric 11900 Network Management and Monitoring Configuration Guide

167
Mirroring group 1:
Type: Local
Status: Active
Mirroring CPU:
Slot 1 Both
Monitor port: Ten-GigabitEthernet1/0/3
Local port mirroring with multiple monitor ports configuration
example
Network requirements
As shown in Figure 58, Dept. A, Dept. B, and Dept. C are connected to Device A through ports
Ten-GigabitEthernet 1/0/1, Ten-GigabitEthernet 1/0/2, and Ten-GigabitEthernet 1/0/3, respectively.
Configure port mirroring to enable all three data monitoring devices (Server A, Server B, and Server C)
to monitor both the incoming and outgoing traffic of the three departments.
Figure 58 Network diagram
Configuration procedure
# Create remote source group 1.
<DeviceA> system-view
[DeviceA] mirroring-group 1 remote-source
# Configure Ten-GigabitEthernet 1/0/1 through Ten-GigabitEthernet 1/0/3 as source ports of remote
source group 1.
[DeviceA] mirroring-group 1 mirroring-port ten-gigabitethernet 1/0/1 to
ten-gigabitethernet 1/0/3 both
# Configure an unused port (Ten-GigabitEthernet 1/0/5, for example) of Device A as the reflector port
of remote source group 1.
[DeviceA] mirroring-group 1 reflector-port ten-gigabitethernet 1/0/5
# Create VLAN 10 and assign the three ports (Ten-GigabitEthernet 1/0/11 through Ten-GigabitEthernet
1/0/13) connecting the three data monitoring devices to VLAN 10.
Dept. A
Dept. B
Dept. C
DeviceA
ServerA
ServerB
ServerC
XGE1/0/3
XGE1/0/2
XGE1/0/1
XGE1/0/11
XGE1/0/12
XGE1/0/13