R211x-HP Flexfabric 11900 Security Configuration Guide

155
Ste
p
Command Remarks
10. (Optional.) Specify an inside
VPN instance.
inside-vpn vpn-instance vpn-name
By default, no inside VPN
instance is specified for an IKE
profile, and the device forwards
protected data to the VPN
instance with the same name as
the VPN instance on the
external network.
11. (Optional.) Specify a priority
for the IKE profile.
priority number
By default, the priority of an IKE
profile is 100.
Configuring an IKE proposal
An IKE proposal defines a set of attributes describing how IKE negotiation in phase 1 should take place.
You can create multiple IKE proposals with different priorities. The priority of an IKE proposal is
represented by its sequence number. The lower the sequence number, the higher the priority.
Two peers must have at least one matching IKE proposal for successful IKE negotiation. During IKE
negotiation:
• The initiator sends its IKE proposals to the peer.
{ If the initiator is using an IPsec policy with an IKE profile, the initiator sends all IKE proposals
referenced by the IKE profile to the peer. An IKE proposal specified earlier for the IKE profile has
a higher priority.
{ If the initiator is using an IPsec policy with no IKE profile, the initiator sends all its IKE proposals
to the peer. An IKE proposal with a smaller number has a higher priority.
• The peer searches its own IKE proposals for a match. The search starts from the IKE proposal with
the highest priority and proceeds in descending order of priority until a match is found. The
matching IKE proposals are used to establish the IKE SA. If all user-defined IKE proposals are found
mismatching, the two peers use their default IKE proposals to establish the IKE SA.
Two matching IKE proposals have the same encryption algorithm, authentication method, authentication
algorithm, and DH group. The SA lifetime takes the smaller one of the two proposals' SA lifetime settings.
To configure an IKE proposal:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an IKE proposal and
enter its view.
ike proposal proposal-number
By default, there is an IKE
proposal that is used as the
default IKE proposal.
3. Specify an encryption
algorithm for the IKE
proposal.
• In non-FIPS mode:
encryption-algorithm { 3des-cbc |
aes-cbc-128 | aes-cbc-192 |
aes-cbc-256 | des-cbc }
• In FIPS mode:
encryption-algorithm { aes-cbc-128
| aes-cbc-192 | aes-cbc-256 }
By default:
• In non-FIPS mode, an IKE
proposal uses the 56-bit DES
encryption algorithm in CBC
mode.
• In FIPS mode, an IKE
proposal uses the 128-bit AES
encryption algorithm in CBC
mode.