R211x-HP Flexfabric 11900 Security Configuration Guide

31
Ste
p
Command Remarks
3. Specify a security policy
server.
security-policy-server { ipv4-address
| ipv6 ipv6-address } [ vpn-instance
vpn-instance-name ]
By default, no security policy server
is specified for a scheme.
You can specify up to eight security
policy servers for a RADIUS scheme.
Enabling SNMP notifications for RADIUS
When SNMP notifications are enabled for RADIUS, the SNMP agent supports the following notifications
generated by RADIUS:
• RADIUS server unreachable notification—The RADIUS server cannot be reached. RADIUS
generates this notification if it cannot receive any response to an accounting or authentication
request within the specified RADIUS request transmission attempts.
• RADIUS server reachable notification—The RADIUS server can be reached. RADIUS generates this
notification for a previously blocked RADIUS server after the quiet timer expires.
• Excessive authentication failures notification—The number of authentication failures to the total
number of authentication attempts exceeds the specified threshold.
You can configure SNMP parameters to control the output of these SNMP notifications. For more
information, see Network Management and Monitoring Configuration Guide.
To enable SNMP notifications for RADIUS:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable SNMP notifications for
RADIUS.
snmp-agent trap enable radius
[ accounting-server-down |
authentication-error-threshold |
authentication-server-down |
accounting-server-up |
authentication-server-up ] *
By default, all types of SNMP
notifications are enabled for
RADIUS.
Displaying and maintaining RADIUS
Execute display commands in any view and reset commands in user view.
Task Command
Display the RADIUS scheme
configuration.
display radius scheme [ radius-scheme-name ]
Display RADIUS packet statistics. display radius statistics
Clear RADIUS statistics. reset radius statistics
Configuring HWTACACS schemes
Configuration task list
Tasks at a
g
lance
(Required.) Creating an HWTACACS scheme