HP FlexFabric 11900 Switch Series About the HP FlexFabric 11900 Configuration Guides Part number: 5998-4056 Software version: Release 2105 and later Document version: 6W100-20130515
Legal and notice information © Copyright 2013 Hewlett-Packard Development Company, L.P. No part of this documentation may be reproduced or transmitted in any form or by any means without prior written consent of Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice.
About the HP FlexFabric 11900 configuration guides The HP FlexFabric 11900 configuration guides describe the software features for the HP FlexFabric 11900 Switch Series, and guide you through the software configuration procedures. These configuration guides also provide configuration examples to help you apply the software features to different network scenarios.
Configuration guide Content • Bulk configuring interfaces • Configuring the MAC address table • Configuring MAC Information • Configuring Ethernet link aggregation • Configuring port isolation • Configuring spanning tree protocols • Configuring loop detection • Configuring VLANs • Configuring QinQ • Configuring VLAN mapping • Configuring LLDP • Configuring service loopback groups Describes how to configure ARP, IP addressing, IP performance optimization, IP forwarding basics, IPv6 basics, DHCP, DNS, UDP he
Configuration guide Content • • • • • • • • • Configuring BGP Configuring PBR Configuring IPv6 static routing Configuring an IPv6 default route Configuring RIPng Configuring OSPFv3 Configuring IPv6 IS-IS Configuring IPv6 PBR Configuring routing policies Covers Layer 3 IPv4 multicast protocols (IGMP and PIM), Layer 3 IPv6 multicast protocols ( MLD and IPv6 PIM), Layer 2 IPv4 multicast protocols (IGMP snooping), and Layer 2 IPv6 multicast protocols (MLD snooping).
Configuration guide Content • Configuring congestion management • Configuring congestion avoidance • Configuring traffic filtering • Configuring priority marking • Configuring nesting • Configuring traffic redirecting • Configuring aggregate CAR • Configuring class-based accounting • Configuring time ranges • Appendix Covers security features. The major security features available on the switch include: identity authentication, secure management, and attack protection.
Configuration guide Content OAA Configuration Guide Introduces OAP and the relevant protocols, and describes how to configure the switch as an OAP manager to communicate with and control OAP modules. FCoE Configuration Guide Describes the application scenarios, fundamentals, and configuration of FCoE. TRILL Configuration Guide Describes the application scenarios, fundamentals, and configuration of TRILL.
