R21xx-HP FlexFabric 11900 ACL and QoS Command Reference

99
red action: Specifies the action to take on the packet that conforms to neither CIR nor PIR. The default
setting is discard.
yellow action: Specifies the action to take on packets that conform to PIR but not to CIR. The default
setting is pass.
action: Specifies the action to take on packets:
• discard: Drops the packet.
• pass: Permits the packet to pass through.
• remark-dot1p-pass new-cos: Sets the 802.1p priority value of the 802.1p packet to new-cos and
permits the packet to pass through. The new-cos argument is in the range of 0 to 7.
• remark-dscp-pass new-dscp: Remarks the packet with a new DSCP value and permits the packet to
pass through. The value range is 0 to 63. Alternatively, you can specify the new-dscp argument with
af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, cs1, cs2, cs3, cs4, cs5, cs6,
cs7, default, or ef.
Usage guidelines
An aggregate CAR action takes effect only after it is applied to an interface or referenced in a QoS
policy.
Examples
# Configure the aggregate CAR action aggcar-1, where CIR is 25600, CBS is 512000, and red packets
are dropped.
<Sysname> system-view
[Sysname] qos car aggcar-1 aggregative cir 25600 cbs 512000 red discard
Related commands
display qos car name
reset qos car name
Use reset qos car name to clear the statistics about the specified aggregate CAR action.
Syntax
reset qos car name [ car-name ]
Views
User view
Predefined user roles
network-admin
Parameters
car-name: Specifies the name of an aggregate CAR action. This argument must start with a letter, and is
a case-sensitive string of 1 to 31 characters. If no car-name is specified, this command clears the statistics
about all the aggregate CAR actions.
Examples
# Clear the statistics about the aggregate CAR action aggcar-1.
<Sysname> reset qos car name aggcar-1