R21xx-HP FlexFabric 11900 ACL and QoS Command Reference

7
display packet-filter { interface [ interface-type interface-number ] [ inbound | outbound ] | interface
vlan-interface vlan-interface-number [ inbound | outbound ] [ chassis chassis-number slot slot-number ] }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface [ interface-type interface-number ]: Specifies an interface by its type and number. VLAN
interfaces are not supported. If no interface is specified, the command displays ACL application
information on all interfaces except VLAN interfaces for packet filtering.
interface vlan-interface vlan-interface-number: Specifies a VLAN interface by its number.
inbound: Specifies the inbound direction.
outbound: Specifies the outbound direction.
slot slot-number: Specifies a card by its slot number. If no slot is specified, the command displays ACL
application information on the main board for packet filtering. (In standalone mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The chassis-number
argument represents the ID of the IRF member device, and the slot-number argument represents the
number of the slot that holds the card. If no card is specified, the command displays ACL application
information for packet filtering on all main boards of the IRF fabric. (In IRF mode.)
Usage guidelines
If you specify neither the inbound keyword nor the outbound keyword, the command displays the ACL
application information for both incoming and outgoing packet filtering.
Examples
# Display ACL application information for incoming packet filtering on interfaces Ten-GigabitEthernet
1/0/1.
<Sysname> display packet-filter interface ten-gigabitethernet 1/0/1 inbound
Interface: Ten-GigabitEthernet1/0/1
In-bound policy:
ACL 2003, Hardware-count
Default action: Deny
Table 2 Command output
Field Descri
p
tion
Interface Interface to which the ACL applies.
In-bound policy ACL used for filtering incoming traffic.
Out-bound policy ACL used for filtering outgoing traffic.
ACL 2003 IPv4 basic ACL 2003 has been successfully applied.
Hardware-count Successfully enables counting ACL rule matches.
Default action
Default action for packets that do not match any ACL. If the default
action is deny, this field displays Deny. If the default action is permit,
this field is blank.