R21xx-HP FlexFabric 11900 ACL and QoS Command Reference

37
• You can configure multiple VLAN IDs in one command line. If the same VLAN ID is specified
multiple times, the system considers the VLAN IDs as one. If a packet matches one of the defined
VLAN IDs, it matches the if-match clause.
• To delete a criterion that matches VLAN IDs, the specified VLAN IDs in the command must be
identical with those defined in the criterion (the sequence may be different).
Defining a criterion to match control plane protocols
• You can configure multiple control plane protocol match criteria for a traffic class.
• You can configure multiple control plane protocols in one command line. If the same control plane
protocol is specified multiple times, the system considers them as one. If a packet matches one of the
defined control plane protocols, it matches the if-match clause.
• To delete a criterion that matches control plane protocols, the specified control plane protocols in
the command must be identical with those defined in the criterion (the sequence may be different).
• To view the system-defined control plane protocol types, use the display qos policy control-plane
pre-defined command.
Examples
# Define a match criterion for traffic class class1 to match the packets with their destination MAC
addresses being 0050-ba27-bed3.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match destination-mac 0050-ba27-bed3
# Define a match criterion for traffic class class2 to match the packets with their source MAC addresses
being 0050-ba27-bed2.
<Sysname> system-view
[Sysname] traffic classifier class2
[Sysname-classifier-class2] if-match source-mac 0050-ba27-bed2
# Define a match criterion for traffic class class1 to match the packets with their customer network 802.1p
priority values being 3.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match customer-dot1p 3
# Define a match criterion for traffic class class1 to match the packets with their service provider network
802.1p priority values being 5.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match service-dot1p 5
# Define a match criterion for traffic class class1 to match the advanced ACL 3101.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match acl 3101
# Define a match criterion for traffic class class1 to match the ACL named flow.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match acl name flow
# Define a match criterion for traffic class class1 to match the advanced IPv6 ACL 3101.