R21xx-HP FlexFabric 11900 ACL and QoS Command Reference

80
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr weight
# Enable byte-count WRR queuing on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr byte-count
Related commands
display qos wrr interface
qos wrr { byte-count | weight }
Use qos wrr { byte-count | weight } to configure the WRR queuing parameters for a queue on an
interface.
Use undo qos wrr to restore the default WRR queuing parameters of a queue on an interface.
Syntax
qos wrr queue-id group { 1 | 2 } { byte-count | weight } schedule-value
undo qos wrr queue-id
Default
All queues are in WRR group 1, and the weights of queues 0 through 7 are 1, 2, 3, 4, 5, 6, 7, and 8,
respectively.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
queue-id: Specifies a queue by its ID in the range of 0 to 7.
group 1: Specifies WRR group 1 or 2.
byte-count: Allocates bandwidth to queues in terms of bytes.
weight: Allocates bandwidth to queues in terms of packets.
schedule-value: Specifies a scheduling weight for the specified queue in WRR queuing, in the range of
1 to 15,
Usage guidelines
You must use the qos wrr command to enable WRR queuing before you can configure WRR queuing
parameters for a queue on an interface.
The queue-id argument can be either a number or a keyword. Table 32 sh
ows the number-keyword map.
Table 32 The number-keyword map for the
queue-id argument
Number Ke
y
word
0 be
1 af1
2 af2