R21xx-HP FlexFabric 11900 ACL and QoS Configuration Guide

4
Tasks at a
g
lance
(Required.) Perform at least one of the following tasks:
• Configuring a basic ACL
{ Configuring an IPv4 basic ACL
{ Configuring an IPv6 basic ACL
• Configuring an advanced ACL
{ Configuring an IPv4 advanced ACL
{ Configuring an IPv6 advanced ACL
• Configuring an Ethernet frame header ACL
(Optional.) Copying an ACL
(Optional.) Configuring packet filtering with ACLs
Configuring a basic ACL
This section describes procedures for configuring IPv4 and IPv6 basic ACLs.
Configuring an IPv4 basic ACL
IPv4 basic ACLs match packets based only on source IP addresses.
To configure an IPv4 basic ACL:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an IPv4 basic ACL and
enter its view.
acl number acl-number [ name
acl-name ] [ match-order { auto |
config } ]
By default, no ACL exists.
IPv4 basic ACLs are numbered in
the range of 2000 to 2999.
You can use the acl name acl-name
command to enter the view of a
named ACL.
3. (Optional.) Configure a
description for the IPv4 basic
ACL.
description text
By default, an IPv4 basic ACL has
no ACL description.
4. (Optional.) Set the rule
numbering step.
step step-value The default setting is 5.